Product manual

EAP01 - Product Manual
3.3 Recommended Installation Procedure
Please read and observe the “Safety and Precautions” section on page 46 of this manual.
!
!
L
The EAP01 Build Standard version is indicated on the label located on the bottom part of the
fist microphone enclosure as shown in Figure 2. This should be quoted in all enquiries
regarding the unit.
1. Open the EAP01 door using the associated KABA key.
2. Remove the EAP01 door by compressing the hinge pin; see Figure 4.
This can be done by inserting a small screwdriver into the holes in the pin, and sliding it upwards or
downwards.
Take care to ensure that the hinge pin’s plastic bushes in the back box are not loosened.
Figure 4 EAP01 Door Removal
SLIDE THE
HINGE PIN
UPWARDS OR
DONWARDS BY
INSERTING A
SMALL
SCREWDRIVER
INTO ONE OF
THE HOLES IN
THE PIN
PLASTIC BUSHES
TIGHTLY FITTED
!
!
Issue: 02 complete, approved
Page 13 of 52