use and_care_guide

42
Customer Care Center, 1-800-898-1879, www.askousa.com
FAILURE DISPLAY
In case of a failure while a program is in progress, the relevant Error X is indicated on the display unit.
Info EXITError 3
5
Press the INFO button to display the
error description.
Switch off the appliance and turn it back
on.
Errors indicated on the display unit may include the following:
Error Error indication on the display unit What to do?
E0 INCORRECT SETTINGS
Restart the programme. If the error reoccurs, call a
service technician.
E1 THERMISTOR ERROR
Temperature sensor error.
• Inlet water too cold. Repeat the washing program.
• If the appliance reports this error again, call a
service technician.
E2 DOOR LOCK ERROR Turn the appliance OFF and then switch it again ON.
Start the program again. If the error reoccurs, call
service technician.
E3 WATER FILLING ERROR Check the following:
• is the water inlet valve open,
• is the filter on the water inlet hose clean,
• is the water supply hose deformed (clipped, clogged
etc.),
• is the pressure in the water mains between
0.1 and 1 MPa (0,1–10 bar).
Then, press the Exit button to resume the program.
If the error reoccurs, call a service technician.
E6 HEATING ERROR
Water heating error.
Restart the program. If the error reoccurs, call a
service technician.
E7 DRAINING ERROR
Water draining error.
Check the following:
• is the pump filter clean,
• is the drain hose clogged,
• is the drain clogged,
• is the drain hose fitted at the right height (see
chapter on drain hose installation in the instruction
manual).
Then, press the Exit button again. If the error
reoccurs, call a service technician.
E7.1 DRAIN SYSTEM ALERT
Water drain system alert.
Alert about reduced water flow in the pumping stage.
Check the following:
• is the pump filter clean,
• is the drain hose clogged,
• is the drain clogged,
• is the drain hose fitted at the right height (see
chapter on drain hose installation).
E10 WATER LEVEL SENSOR ERROR Turn the appliance OFF and then switch it again ON.
Start the program again. If the error reoccurs, call
service technician.