Service manual

Fault indicators TD70.2 cont.
In the case of a fault the following fault indicators are shown on the display.
Troubleshooting
Display Cause Action
Clean condenser, Rengör
kondensor, Rens kon.
sator, Rens kon.sator,
Puhdista lauhdutin,
Nettoyage condenseur,
Reinigen kondensor, Pulizia
condensatore, Limpiar
condensador, Oчистить
кoндeнсaтoр, Kondenser
reinigen
1. Displayed automatically every
100 cycles.
2. Displayed if the machine has indicated
“Clean filter” twice in a row.
Check whether the customer has:
• Cleaned the condenser and the filter.
• Cleaned the other air passages.
Clean Lint Filter, Clean Lint
Filter, Rengör filtret, Rengør
fnugfilter, Rens filter, Puhdista
sihti, Nettoyage filtre, Reinig
filter, Pulizia filtro, Limpie el
filtro, Oчистить фильтp, Sieb
reinigen
Check whether the customer has:
• Cleaned the lint filter.
Clean auto filter, Rengör
autofilter, Rens aut. filter,
Rengjøring autofilter, Puhd.
autom. suodatin, Nett. filtre
auto, Auto. filter reinigen,
Pulizia filtro auto, Limpiar
el autofiltro, Очистите
автофильтр, Autofilter
reinigen
1. Displayed automatically every 10 cycles Check whether the customer has:
• Cleaned the water filter.
HP (heat pump)
Clean filter, Rengör filter,
Rens filter, Rengjøring filter,
Puhd. suodatin, Nett. Filtre,
Filter reinigen, Pulizia filtro,
Limpiar el filtro, Очистите
фильтр, Filter reinigen
Check whether the customer has:
• Cleaned the evaporator filter (net filter
+ foam filter) and the evaporator.
HP (heat pump)
After carrying out corrective actions as above, reset the fault indication on the display by switching off the machine
at the main power switch.
Service Manual TD70
28