Operating instructions

The machine will not start
Check
• that the door is properly closed.
• that the main power switch is on.
• that the Delayed Start option has not been
selected. To cancel Delayed Start, press the
Stop button for three seconds.
• that the plug is connected.
• that the main fuses have not blown.
• that the overheating cut-out has not been
triggered.
The machine loses all power during
a program
The overheating cut-out shuts off the tumble dryer
if the temperature is too high, e.g. because dust
is clogging the lint filter.
• Clean the lint filter.
• Check also that the condensed water container
is not full and, if necessary, clean the
condenser. See the Care and cleaning chapter.
• Wait until the machine has cooled then try
starting it. If it still does not start: Call the
service division.
Drying takes too long
• Check that the lint filter is not blocked. See the
Care and cleaning chapter.
• Empty the condensed water container and
check that the condenser is not blocked. See
the Care and cleaning chapter.
• Overly long drying times may also be due to
the tumble dryer being located in a confined
area or in a room that is too small, causing the
air to become too hot.
• Make sure that the tumble dryer has access
to more cold air, open doors and/or windows,
for example.
Error messages
• If Over Flow appears on the display, the
condensed water container is full. Empty the
container and restart the machine.
• Read Drying takes too long in this chapter if
Max program time appears on the display.
• If Clean Lint Filter appears on the display, clean
the lint filter.
• If Clean condenser appears on the display,
clean the condenser. See the Care and
cleaning chapter.
• Call the service division if Thermistor fault
appears on the display.
• Press the Stop button to close any error
messages.
21
Troubleshooting