Operating instructions

The machine will not start
Check
•
that the door is properly closed.
•
that the main power switch is on.
•
that the machine is not programd to start at a
specific time (e.g. 13.30)
•
that the plug is connected.
•
that the fuses (circuit breakers) in your house
are intact. Swap two circuit breakers over to
make sure. You cannot always tell from the
outside if a circuit breaker is broken.
•
that the overheating cut-out has not been trig-
gered (see below).
Overheating cut-out
The overheating cut-out shuts off the tumble dryer
if the temperature is too high, e.g. because dust
is clogging the lint filter.
•
Clean the filter.
•
Check also that the condensed water container
is not full and, if necessary, clean the con-
denser. See the chapter “Care and cleaning”.
•
The overheating cut-out will reset automatically
once the machine has cooled down.
Drying takes too long
•
Empty the condensed water container and
check that neither the lint filter nor the con-
denser is clogged. See the chapter "Care and
cleaning".
•
Overly long drying times may also be due to
the tumble dryer being located in a confined
area or room that is too small, causing the air
to become too hot.
•
Make sure that the tumble dryer has access
to more cold air, e.g. by opening doors and/or
windows.
The washing does not dry, or is too
dry
•
The door has been opened while the program
is running, which disrupts the moisture monitor-
ing function.
Error messages
•
If “Over Flow” is shown in the display, the
condensed water container is full. Empty the
container and restart the program.
•
If "Max program time" appears on the display,
the maximum program time has been reached.
Read "Drying takes too long" in the "Trou-
bleshooting" chapter to find out what to do.
•
If "Clean lint filter" appears on the display,
clean the lint filter.
•
If "Clean condenser" appears on the display.
See the "Cleaning the condenser" section of
the "Care and cleaning" chapter for remedy.
•
If "Thermistor fault" is shown on the display
call the service division.
•
Press the Stop button to close error messages.
19
Troubleshooting