Operating instructions

Cleaning the lint filter

The lint filter must be cleaned after each load. If

you have very hard water, this can cause

limescale deposits in the lint filter. Check for any

limescale deposits when cleaning the lint filter

and, if necessary, wash the filter by hand.

Grasp the filter handle and pull it towards you.

Pull the filter out of its holder.

Open the filter and remove the lint from all

sides of it by hand. Use a soft, dry cloth to re-

move any deposits.

Replace the filter in its holder.

Note!

If you have hard water, the filter should be washed

with water to get rid of any limescale deposits.

Use a sponge and a little dishwashing detergent

if necessary. Dry the filter carefully with a towel.

If you cannot remove the limescale, you can buy

a new filter from the retailer where you bought the

tumble dryer.

Emptying the condensed water

container

The condensed water container must be drained

after each load. Remove the condensed water

container, empty out the water and replace the

container. If the condensed water container be-

comes too full, the program is interrupted and

"Over Flow" appears on the display. Empty the

container and press the Start button to restart the

program. See also the "Troubleshooting" chapter.

Note!

Do not remove the condensed water container

while the machine is running.

Cleaning the outside of the machine

Clean the outside of the machine and the program

panel with a mild cleaner. Do not use solvents,

as these can damage the machine. Do not hose

down or spray the machine with water.

Note!

Do not allow dust to accumulate around the ma-

chine. Keep the area around the tumble dryer

clean and cool; dust, heat and moisture prolong

drying times.

Care and cleaning