Technical data

8
EASYINSTALL
™
DISHWASHERS
ASKO’s dishwashers come with all the
connections you need. We’ve eliminated
the need to get into the electrical and
mechanical area, which makes installation
simple and quick. If a dishwasher is being
installed in an area for the first time, most
of the cabinetwork, plumbing, and electrical
has to be done before you move the
machine into place. If you are replacing
an old dishwasher, you must check the
plumbing connection and wiring before
you install the new dishwasher.
This system has these components
which have been approved by regulatory
authorities (cUL):
• Over 5' of Pex hose that replaces
the water-inlet copper tubing. It
has a 3/8"-compression fitting that
mates with a 3/8" shut-off valve.
Length: 5'2" from back of unit.
• Over 6' of drain hose with an adaptable
drain connection. The high loop is built
into this hose on the back of the unit.
Length: 6'6" from back of unit.
• A 6' long electrical cord with
standard, 3-pronged, 120V plug.
This eliminates the need to wire
anything under the unit.
• Front-adjustable rear leg. You can
raise or lower the rear leg from the
front of the unit simply by using a
flat-head screwdriver to rotate the
adjusting screw.
Back of ASKO dishwasher with EasyInstall system.
Pex hose with 3/8" brass fitting.
Already wired with a standard
three-pronged plug.
Front-adjustable rear leg.
Drain hose with multiple size
adaptor.