Technical data

25
Specifications are subject to change without notice. See installation instructions for additional details.
Planning & Design: Dryers
T721, T781 condenser dryers
The door hinges on ASKO dryers are shipped left-hinged, but they are reversible.
See the Dryer Use and Care Guide for more information.
When placing the dryer next to a wall or cabinet, be sure to leave 1/2" (12 mm) of
space between the dryer and the wall or cabinet.
See page 27 for stacked washer/dryer dimensions.
See pages 28–30 for cutout dimensions for closet and under-cabinet installations.
Condensation Drain Requirements
If possible, you should install the dryer so the condensed water will
continuously flow into a drain or sink. To do this, follow the
instructions below:
1. Disconnect the short hose (1) from the blue connection.
(It’s okay to let the hose hang down.)
2. Connect the rubber hose supplied with the dryer to the blue nipple (2).
3. Run the hose to a drain or sink, as illustrated.
NOTE: Power cord not supplied with unit.
NOTE: The drain hose must not be more
than 40" above the floor or the bottom of
the unit.
Unit Dimensions
US METRIC
HEIGHT 33-1/2"–34-1/2" 850–876 mm
WIDTH 23-7/16" 595 mm
DEPTH: T721 24-7/16" * 621 mm
T781 23-7/16" 595 mm
DEPTH W/DOOR OPEN 46-1/16" 1170 mm
WEIGHT 103 lb 47 kg
Technical Data
Supply voltage Single-phase
230 V, 60 Hz
Heating element 2500 W
Internal Fuse 15 A
NOTE: When on a separate outlet, use
220 V, 20 Amp single-phase circuit. When
an ASKO washer is connected, use 220 V,
30 Amp single-phase circuit.
1
3
3
40"
(1016 mm)
maximum
height
2
Back of dryer
*Includes 1" for control knob.