Owner's Guide

8
Customer Care Center, 1-800-898-1879, www.askousa.com
BUILT-IN
4-1/2"
8-3/4"
222 mm
115 mm
29-7/8"
758 mm
ASKO dryers can be installed beneath a cabinet
or worktop with a minimum height of 34” (864 mm).
There must be a gap of about 1/2” (12 mm) all
around the machine, including between the rear
edge of the machine and the back wall. The opening
width must be at least 24-1/2” (622 mm).
The height adjustment for the dryer is 33-1/2” to
34-1/2” (850 mm to 876 mm). Do not raise it higher
than 34-1/2” (876 mm). Hole measurements are from
center of hole.
Closet Install- Ventilation Requirements
ASKO's front panel controls make it possible to
install the washers and dryers in a closet. Make
sure there is a ½” (12 mm) minimum clearance
between units and cabinet or wall. To ensure
proper ventilation, we recommend louvered doors.
Otherwise there must be ventilation openings in
the door. See illustration for minimum ventilation
openings below (gray boxes):
Ensure the dryer door can be opened without
hindrance after installation.
The cool air intake panel at the front of the dryer
must not be blocked or covered. Doing so could
cause a fault.