Service manual

8
Connectiontowatersupply
The supply pipe must be tted with a stop-
cock. The stopcock should be positioned
above the sink unit or at the front of the sink
unit cabinet.
The inlet pipe has a coupling with either a 1/2”
or a 3/4” internal thread, depending on the
country.
Once the machine in installed: Open the stop-
cock to ush the pipe. Check that all connec-
tions are watertight.
Electrical connection
Machines tted with a cable and plug must be
connected to an earthed socket.
Technical data
See the type plate on the right-hand side of
the door.
CAUTION!
The power cable must be disconnected or the
power to the socket turned o when work is
carried out!
Drain connection
• The drain hose connects to a connection
nipple on the sink unit’s water trap (see illus-
tration below). Note that the hose must be at-
tached at the same height as the underneath
of the sink unit otherwise dishwater from the
sink may run down into the dishwasher (see
illustration).
• The drain hose connects to a connection
pipe on the sink unit’s water trap. It must have
an internal diameter of at least 16 mm.
• The drain hose may be extended to a maxi-
mum of 3 m. Any connections and connect-
ing pipes must have an internal diameter of at
least 16 mm.
• No part of the drain hose may be more than
950 mm above oor level.
The hose must not be routed directly to the
oor drain or similar. In such cases, the hose can
act as a siphon and empty the machine.
The hose must always discharge at least 350
mm above oor level.
• Attach the hose holder.
(Min. 350 mm and max. 950 mm above oor
level.
Figure 3.
Hose holder
Max 950 mm
Min 350 mm
INSTALLATION