Specifications

27
Specifications are subject to change without notice. See installation instructions for
additional details.
PLANNING & DESIGN: 


Shorten
CUSTOM PANEL
DIMENSIONS
 23
5

8
˝ min
*
(600 mm)
 30
1

8
˝ (765 mm
(Measured from the top
of the panel to the
lower edge of the
kitchen cabinet.)
 ¾˝ (19 mm)
*
Max panel width cannot exceed cutout dimensions less
1

8
˝ (3 mm) reveal on each side.
**
With use of optional FI trim kit. Custom door panel height or position should adjust

The ASKO panel ready models can be installed with a fully-integrated,
buyer-supplied custom door panel or ASKO accessory panel (see page 10)

with everything needed to make installing the door panel easy. The door is
predrilled for the panel´s mounting screws.
The custom panel should be a minimum of ¾˝ (19 mm) thick.
Items Provided With The Unit
 
3

8
˝ (10 mm) screws
 ˝ (44 mm) screws
Installing The Custom Panel or ASKO
Accessory Panel – 4˝ (102mm) Reveal
Before fitting the door panel, the dishwasher must be installed
underneath the cabinet. After you´ve made the required
measurements, pull the machine out again to install the panel.

1. Fit the handle (A) onto the panel according to the
manufacturer´s instructions. (NOTE: A handle should be
used rather than a knob, because a knob does not provide
enough grip.)
 The custom panel must not
obstruct the fan exhaust vent; otherwise, moisture
from the vent could eventually damage the cabinet
and create drying problems.
2. The two short screws (B) go into the back of the panel, 15˝ (381
mm) (no top trim) or 15
3

8
˝ (391 mm) (with top trim) from the upper edge
of the panel and 10
7

8
˝ (276 mm) from the center of the panel. Insert the
short screws into the panel, leaving
1

8
˝ (3 mm) of space between the
screw head and the panel.

4. Slide the panel to the left until it is centered in the opening, and
secure the screws.
5. Open the door and use the six screws (D) supplied to secure the
panel to the door.
NOTE: Refer to page 10 for information regarding spring weights and part numbers
30
1
/
8
˝
(765 mm)
3
/
8
˝
(10 mm)
¾˝
(19 mm)
2
1
/
8
˝
(54 mm)
15˝ or 15
3
/
8
˝ **
(381 or 391 mm)
10
7
/
8
˝
(276 mm)
23
5
/
8
˝
min*
(600 mm)
10
7
/
8
˝
(276 mm)
7
11
/
16
˝
(195 mm)
17 ½˝
(445 mm)
Tu rbo fan
exhaust vent
B
B
A
C
C
D
D
D
C
Adjusting The Door Springs
Before you push the dishwasher into
the cabinet opening, test the door to
make sure it stays in place at any angle.
If necessary, pull out the machine and
adjust the tension of the door springs
on the sides of the machine
by moving them one hole
further back or by
twisting the spring
to make it shorter.
*
Models D5894XXLFI
& D5554XXLFI feature front-adjusting
door springs