Technical information

18
1. Check that all parts are mounted. If not
- go through all the steps once more.
2. Check that no packing material is left lying
around.
3. Use a mild washing up product with warm
water and wash the drying cabinet inside
and out. Dry it carefully. See also the sec-
tion ’Care’ further on in the manual.
4. Put the plug in and press on ’START’ (only
certain markets).
5. Read the section ’How to use the drying
cabinet’ further on in the manual.
6. Put the temperature selector knob on
’Normal’ position (full heat) or on the cor-
responding symbol (see figure) and the
time selector knob on approximately 20
minutes.
If the drying cabinet does not start,
check the following:
- that the door of the drying cabinet is
shut
properly
- that the temperature and time selector
knobs are activated.
- that the ’START’-button has been
properly
pressed in (only certain markets).
- that the drying cabinet is connected
to the mains electricity supply.
- that the fuse is in working order
7. When the drying cabinet has been on for
5 minutes, open the door and feel if it is
giving out heat.
If the cabinet is not giving out any
heat, even though the temperature
selector knob is activated and the fan
is functioning, turn the temperature
selector knob back to zero and wait
30 minutes. Then try again by first
putting the temperature selector knob
on ’Normal’ (or the corresponding
symbol) and then start the fan by
turning on the time selector knob. See
also the section ’Troubleshooting’.
Symbol for ”Normal” (full) heat
Final check