Technical information

16
1
2
3
4
7. Fix the two parts of the wooden strip in
place using two screws, each of them
screwed into the wall behind the drying
cabinet, so that they correspond with the
holes marked as in point 4. Use screws
of a suitable length.
8. Push back the drying cabinet into the
mounting unit. Take off the adhesive
tape holding the door and check that the
wooden strip is in place on the back wall
of the drying cabinet. Also check that the
front part of the drying cabinet fits well
into the cabinet mounting unit.
9. Adjust the position of the drying cabinet
horizontally according to the instructions
in the section ”Horizontal adjustment”
and screw the drying cabinet firmly down
into place according to the instructions
in the section ”Mounting” on page 12.
1. Attachment screws
2. Hole marking
3. Air flow
4. Wooden strip (in two parts)
~150 mm
The cabinet mounting unit with assemb-
led wooden strip, divided into two parts,
to allow free passage of air
ATTENTION
Check that the wooden strips are
properly and firmly in place in the back
wall and also that the assembly screws
do not obstruct the assembly holes in
the drying cabinet.