Use & Care Guide
Table Of Contents
- Front page
- Contents
- Your dishwasher
- Important safety instructions
- Before washing for the first time
- Greener dishwashing
- Loading the dishwasher
- Using the dishwasher
- Add detergent
- The main power switch
- Select program
- Select program mode
- Select option
- Starting the dishwasher
- Time remaining
- Stopping or changing a program
- If you want to load more dishes
- If the dishwasher is turned off due to a power failure
- Once the program has finished
- How to get the best drying results
- Unloading the dishwasher
- Program chart
- Settings
- Care and maintenance instructions
- Troubleshooting
- Installation instructions
- Service
- Technical information
Placing the dishwasher
The dishwasher is intended to be built in under a countertop. The built-in measurements are shown
in the illustration. Make sure that the cord and hose hole's edges are even and will not damage the
drain and inlet hoses or the power cord.
['']
* 32 1/4'':
The electrical and
water supplies
should enter
through the area
indicated by the
shading on the
illustration.
Remove the trim kit.
NOTE!
Framed cabinets require additional finished filler material behind the face frame for a proper in-
stallation. A minimum 3½” (89 mm) finished return is required on all sides of the opening.
Frameless
cabinetry
Filler
Framed
cabinetry
If the dishwasher is built-in, the surrounding furnishings must be resistant to any condensation from
the dishwasher.
Fit the protective film
Affix the protective film (packed in the document bag). The protective film is to protect the countertop
from moisture.
36
Installation instructions