User Manual

EN 13

Montage

Drilling the support surface and fitting the Hood

• The hood can be fitted directly on the lower surface of the wall units

using the snap-on Side Supports.

• Make an opening on the lower surface of the wall unit, as indicated.

• Screw the closing profile 20 onto the rear part of the hood, using

the screws 12e (2.9 x 12.7) provided.

• Open the glass panel.

• Remove the metal grease filters one by one by turning the hooks

provided.

• Close the glass again.

• Insert the hood until the snap-on side supports click into place.

• Open the glass panel.

• Lock in position by tightening the screws Vf from underneath the

hood.

437

255

437

255

12a

INSTALLATION