Dear Customer, Thank you for choosing this quality product from ASKO. We hope it will meet your expectations and fulfill your needs for many years to come. Scandinavian design combines clean lines, everyday functionality, and high quality. These are key characteristics of all our products and the reason they are greatly appreciated throughout the world. To get the most out of your new dishwasher, we recommend that you read the operating instructions before using it.
Contents Display panel Important safety instructions Before washing for the first time Loading the dishwasher Using the dishwasher Settings 2 3 4 5 7 11 Care and maintenance instructions Troubleshooting Technical information Service Program chart Notes 13 15 18 19 20 21 Display panel 1 2 3 4 5 6 7 8 9 10 11 12 1 On/Left-on mode 5 Rinse aid indicator 9 Delayed start 2 Program selector 6 Child lock (button lock) 10 Set time (for the Time program) 3 Program symbol 7 High temperat
Important safety instructions SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE WARNING! When using your dishwasher, follow basic precautions, including the following: • Read all instructions before using the dishwasher. • Use the dishwasher only for its intended function. • Use only detergents or wetting agents recommended for use in a dishwasher and keep them out of the reach of children.
Before washing for the first time Disposal Water supply • When the machine has reached the end of its service life and is to be disposed of, it should immediately be made unusable. Pull out the power cable and cut it as short as possible. • The dishwasher is manufactured and labeled for recycling. • Contact your municipality for information about where and how your dishwasher can be recycled correctly. The machine can be connected to either a cold 1) or a hot (max. 160 °F (70 °C)) water supply.
Loading the dishwasher Setting the rinse aid dosage Economic dishwashing The section Settings describes how to set rinse aid amount. The rinse aid amount can be set from (Off) to (High dose). (Factory settings: ) Run programs only with a full load Wait until the dishwasher is fully loaded before running a program, this way you save energy. Use the Rinse & Hold program to rinse the dishes if there are any unpleasant odors while you wait for the dishwasher to become fully loaded.
Typical load for 10 place settings Upper basket Place glasses, cups, bowls, side plates, and saucers in the upper basket. Place all soiled surfaces down! Place wine glasses on the wine shelf. Place knives on the knife stand, if applicable. Upper basket with 10 place settings AHAM DW-1 NOTE! Ensure the upper basket is set to its lowest position. Raising the upper basket 1 Pull out the upper basket. 2 Grab the sides of the upper basket with both hands and lift it up.
Using the dishwasher Add detergent 1 Prewash detergent compartment Foldable tines Lower the foldable tines when washing large pots. Release the foldable tines by pressing the catch inward before adjusting their position. Washing large plates Move adjustable tines and their mounts to widen the distance between the tine rows to adapt the lower basket to plates with a diameter greater than 9 3/4" (25 cm).
WARNING! Children must be supervised – dishwasher detergent is corrosive! Sanitation wash A program that is able to deal with most household germs and particularly dirty dishware. This program uses a high final rinse temperature for good drying results and to kill germs. NOTE! NB: Do not load dishware that cannot withstand high wash or rinse temperatures.
Selecting Options To select an option, press one of the option buttons. The field under the button lights when the option is activated. The available options depend on the selected program. Once you have started the program, the options you selected are saved for the next time you use the same program. An exception is the Delayed start option. High temperature Activate this option for improved dishwashing results. The machine then uses a higher temperature for the main wash.
Once the program has finished Once the program has finished and the door is opened, "End" appears on the display. At the end of the program, one short signal will sound. Chapter Settings describes how to change this function. Once the cycle is complete, the dishwasher uses standby power only. Shut off the water supply valve after every use.
Settings Do as follows to open the settings menu: + 1. First, open the door. Turn off the dishwasher using the On/Left-on mode button (press and hold). Release the button. 2. Press and hold the On/Left-on mode button until the display lights up. 3. Within five seconds, press and hold the Program selector and the Long dry button. 4. Release the buttons when the display shows . TIP! Be sure to press right on the symbols, so as not to inadvertently activate any other button.
Button press Options (Off) Settings Description Operation volume This sound is used to confirm each button press. (Low) (High) Press Start/Stop to save the setting value and continue to the next setting. (Low) LCD contrast For adjusting the contrast of the display on the panel. (High) Press Start/Stop to save the setting value and continue to the next setting. (Off) Rinse aid (Low dosage) (High dosage) Press Start/Stop to exit the settings menu. 12 Rinse aid dosage setting.
Care and maintenance instructions Coarse filter NOTE! The coarse filter traps larger food particles, which cannot get past the drain pump. Empty the coarse filter as necessary. The dishwasher must not be used without the filters in place! 1 Lift the coarse filter by the handle. Dishwashing results may be affected if the coarse filter is incorrectly fitted. 2 Empty the coarse filter. Remember to replace it! Drain pump Coarse filter The pump can be accessed from inside the dishwasher.
Winter storage If the dishwasher is to be stored outdoors where the temperature can fall below freezing, do as follows: 1 Look under the cabinet adjacent to the dishwasher for a white, plastic type hose leading away from the dishwasher. This hose is the dishwasher PEX fill hose. Follow this hose away from the dishwasher to where it connects to a shut-off valve. Turn this shut-off valve completely off. Lower spray arm • Pull the lower spray arm straight up to release it.
Troubleshooting Display Type of fault Overfilling 1) Action 1) Call the Customer Care Center. Water outlet fault 1) See "Water remains in the dishwasher above the filters" in the table below. Water inlet fault 1) Check that the water supply valve is on. Inlet valve leakage 1) Turn off the water supply valve and call the Customer Care Center. Turn off the machine with the On/Left-on mode button and then turn it on again to clear the error message from the display.
Problem Possible causes Action The dishwasher does not start. The Start/Stop start button has been pressed Press and hold Start/Stop until the display for too short a time. shows (the door open symbol). This indicates that the dishwasher is ready to start. The door is not closed properly or was not closed immediately after pressing the Start/Stop button. Close the door within four seconds, otherwise the dishwasher will not start. A fuse/circuit breaker has been tripped. Check.
Problem Possible causes Action Cannot close door. The baskets are not correctly positioned. Check that the baskets are correctly positioned horizontally. Check that the dishes are not blocking the baskets from sliding properly into place. The touch buttons do not react when pressed. You have pressed the touch buttons too soon Wait a moment then try again. after opening the door. Dirt on the touch buttons. Clean with a dry or slightly damp cloth.
Technical information Technical data Height: 35" - 35-3/4" (889-908 mm) Width: 24-5/8" (625 mm) Depth: 25" (635 mm) Weight: 163 lb (74 kg) 1) Water pressure: 4.2–140 psi Electrical connection: See serial number plate Rated power: 1) 18 See serial number plate Weight can vary due to different specifications.
Service Limited Warranty – Residential Appliances ASKO Distribution North America, LLC. (“ASKO”) warrants to the original purchaser (the “ASKO Customer”) of the ASKO product (the “ASKO Product”), who purchased the ASKO Product from a distributor, dealer, manufacturer’s representative or other seller who has been authorized by ASKO, that this ASKO Product is free of defects in materials and/or workmanship, subject to the terms and conditions set forth herein.
Energy label information is based on this program. This program is recommended for daily, regular, or typical use to completely wash a full load of normally soiled dishes, such as plates, serving dishes, cups, and glasses. No options are recommended. 0.8 2.6 2.9 3.7 2.6 3.2 3.8 4.7 2.9- 5.0 Connection to hot water, approx. 120 °F (50 °C). 0.01 0.9 0.5 0.5 0.1 0.7 0.7 0.9 0.4-1.2 4) 0:06 0:50 2:15 1:35 0:20 2:10 2:00 3:00 0:15-2:30 Connection to cold water, approx.
Notes 21
Notes 22
Notes 23
Quick guide Load the baskets 1. (See page 5.) Do not rinse dishes under running water before loading them in the dishwasher. Simply scrape off large food particles before loading the dishwasher. Check that the spray arms can rotate freely 2. Check also that the water supply valve is on. Add detergent 3. 4. The detergent compartment has a small compartment for prewash and a large compartment for the main wash. (See page 7.
