User Guide

Page 7
1. Position the machine in front of the cabinet
opening.
2. Make the height adjustment while the dishwasher
is in front of the opening.
3. Pull out the drain hose to ensure there are no sharp
bends.
4. On the bottom rear of the dishwasher there is a
black ziptie around the rubber buffer that holds the
circulation pump in place. Cut the ziptie and remove
it.
5. Start to feed water, electric, and drain lines into
position.
6. Make sure you’ve put the protective slides on the
rear legs to prevent damaging the floor when you
slide the unit into place (see page 6).
7. Gently slide the unit into the dishwasher opening.
As you do this, feed the drain line into the drain line
hole. Also, feed the electrical and water lines to the
WARNING! Be careful of sharp edges.
1. Connect supply cable with
a UL-listed strain relief
bushing (if nonmetallic
cable is to be used).
2. Connect branch circuit
white lead to white lead on
main terminal block.
4. Connect ground wire to ground on terminal block.
3. Connect branch circuit black lead to brown lead on
main terminal block.
WARNING! Before starting this procedure, be sure
There are four screws that hold the guard plate in place,
two on the upper/underneath side and two on the front.
To remove the guard plate, first remove the toe kick
brackets (see page 6). Then remove the two screws on
the upper/underneath side of the guard plate. Next,
remove the two screws from the front side of the guard
plate.
REMOREMO
REMOREMO
REMO
VING VING
VING VING
VING
THE GUTHE GU
THE GUTHE GU
THE GU
ARD PLAARD PLA
ARD PLAARD PLA
ARD PLA
TETE
TETE
TE
Guard plate
Remove the two
screws on each
side of the guard
plate.
As you slide the unit into place, feed the drain line into
the drain line hole and the electrical and water lines to
the right front of the dishwasher.
CONNECTING THE ELECTRIC CABLECONNECTING THE ELECTRIC CABLE
CONNECTING THE ELECTRIC CABLECONNECTING THE ELECTRIC CABLE
CONNECTING THE ELECTRIC CABLE
MOMO
MOMO
MO
VING VING
VING VING
VING
THE MATHE MA
THE MATHE MA
THE MA
CHINE INTCHINE INT
CHINE INTCHINE INT
CHINE INT
O PLAO PLA
O PLAO PLA
O PLA
CECE
CECE
CE
After the screws are removed, grip the bottom of the
guard plate and pull it toward you to remove it. You can
now access the inlet valve, electrical connection, and
drain pump and hose, as illustrated below.
Remove the two
screws on each
side of the guard
plate.