User Guide

Page 4
WARNING! Plumbing connections must comply with
applicable sanitary, safety and plumbing codes in your
area.
The machine should preferably be connected to a hot
water supply. If a cold water supply is used, the washing
times will be longer but the performance will not be
affected.
The hot water supply line should be minimum 3/8" OD
copper tubing. The inlet valve has a 3/8" NPT female
connection.
After determining where the water supply line will enter
the dishwasher, drill a 1" access hole and run the line
to the approximate inlet valve location shown in the figure
below. The inlet valve is on the right front of the machine,
so the water line should be placed on the right side.
If you use soft copper line, leave the tube straight out in
the opening to slide the dishwasher in. Bend the tube
into position after the dishwasher is slid into the cabinet
opening.
For service convenience, a shut-off valve (not supplied)
should be installed in the supply line in an easily
accessible location (such as, beneath the sink) or in
the supply line near the dishwasher fill valve.
It is important that the water supply line and the shut-off
valve have a sufficient flow volume. At last 3 gallons (12
liters) per minute must be able to pass through the
line. The water pressure should be 18-176 psi.
CORNER INSTCORNER INST
CORNER INSTCORNER INST
CORNER INST
ALLAALLA
ALLAALLA
ALLA
TIONTION
TIONTION
TION
2” clearance
If the dishwasher is installed in a corner, there must be
a minimum clearance of 2 inches (50 mm) from the
side wall so the door can open.
CONNECTIONSCONNECTIONS
CONNECTIONSCONNECTIONS
CONNECTIONS
Compression sleeve
Compression nut
3/8” OD copper
water line
90° street elbow
90° compression elbow
3/8” NPT one end
Inlet valve, 3/8” OD
HOHO
HOHO
HO
T T
T T
T
WW
WW
W
AA
AA
A
TER SUPPLTER SUPPL
TER SUPPLTER SUPPL
TER SUPPL
YY
YY
Y
INSTINST
INSTINST
INST
ALLAALLA
ALLAALLA
ALLA
TIONTION
TIONTION
TION
(1) Hot water supply
(2) Shut-off valve
(not supplied)
(3) Alternate locations
(4) & (5) Tubing
You should only install the number 4 tubing
before you push the machine into position.
Tubing number 5 is to be fitted when the
machine is in position.
NOTE:
In order to prevent heat damage to the inlet valve, all
solder connections must be made before the water
line is connected to the dishwasher.
WARNING!