User's Manual

PAGE 22
5. SETTING UP A PACKET SWITCHED DATA CALL
Before attempting the Data connection, ensure you are registered to the network.
Also, the APN for your operator should be set correctly in the module. This can be
done with the following AT command:
AT+CGDCONT=1,”IP”,”internet”
Alternatively, you can enter +CGDCONT=1,”IP”,”internet” into this field:
Device Manager → Choose ASKEY WWAN – Modem #2 → content
You only have to set this command once for each module as this setting is stored in
the non-volatile memory of the module.
To verify the APN setting, just type this command: AT+CGDCONT?
5.1 Using Modem interface (Dial-up)
It is possible to set up a data call using Windows RAS dial-up networking. This section
explains how to set up a RAS dial-up connection.