User Manual

Cana da . I ndust r y Cana da ( I C)
This device com plies w it h RSS210 of I ndust ry Canada.
CAUTI ON : Exposure t o Radio Frequency Radia t ion. The in st a ller of t h is r a dio e qu ipm ent
m ust e nsure t hat t he ant enna is loca t ed or pointed such that it doe s not em it RF fie ld in excess of
Healt h Ca n ada lim it s for t h e gene ral popula t ion . Consult Sa fet y Code 6 , obt ainable from h ealt h
Cana da’s w ebsit e w w w .hc- sc.ca / rpb.
1. This Transmit t er must not be co-locat ed or operat ing in conj unct ion wit h any ot her ant enna or
t ransmit t er.
2. This equipment complies wit h FCC RF radiat ion exposure limit s set f ort h for an uncont rolled
environment .
3. Any changes or modif icat ions (including t he ant ennas) made t o t his device t hat are not expressly
approved by t he manuf act urer may void t he user’ s aut horit y t o operat e t he equipment .
This device is int ended only f orm OEM int egrat ors under t he following condit ions:
1) The t ransmit t er module may not be co-locat ed wit h any ot her t ransmit t er or ant enna.
IMPORTANT NOTE: In t he event t hat t hese condit ions can not be met (for example cert ain lapt op
conf igurat ions or co-locat ion wit h anot her t ransmit t er), t hen t he FCC aut horizat ion is no longer considered
valid and t he FCC ID can not be used on t he f inal product . In t hese circumst ances, t he OEM int egrat or will be
responsible f or re-evaluat ing t he end product (including t he t ransmit t er) and obt aining a separat e FCC
aut horizat ion.
End Product Labeling
The f inal end product must be labeled in visible area wit h t he following:
Cont ains TX FCC ID: H8N-WLU6120; IC: 1353A-WLU6120
End Product Manual Inf ormat ion
The user manual f or end users must include t he following informat ion in a prominent locat ion
"IMPORTANT NOTE: To comply wit h FCC RF exposure compliance requirement s, t he ant enna must not be
co-locat ed or operat ing in conj unct ion wit h any ot her ant enna or t ransmit t er.
Operat ion is subj ect t o t he following t wo condit ions: (1) t his device may not cause int erf erence, and (2) t his
device must accept any int erference, including int erf erence t hat may cause undesired operat ion of t he
device.