802.11 b/g/n 2.
802.11 b/g/n 2.4G Band 1T1R AP Module WLL6540(RoHS) 1. Product (module) photo 2. Module dimensions 3. Antenna info Part number: 2108517-1 Antenna type: stamped metal antenna Max Peak gain: 2.
4. Feature: The WLL6540(RoHS) module integrates a 1T1R 802.11n WI-FI radio, 1-Port fast Ethernet PHY, USB2.0 host, I2S/PCM and 4 GPIO. This module embedded high performance process a CPU can process advanced applications effortlessly, such as routing, security and VoIP; and includes variety of applications, such as a USB port for accessing external storage. ◆Embedded MIPS24KEc（575/580MHz）with 64KB I-Cache and 32 KB D- Cache ◆1T1R 2.4GHz with 150Mbps PHY data rate ◆Legacy 802.11b/g and 802.
6.
USA - Federal Communications Commission (FCC) FCC Radiation Exposure Statement Interference Statement These devices comply with Part 15 of the FCC Rules. Operation of the devices is subject to the following two conditions: (1) The devices may not cause harmful interference, and (2) The devices must accept any interference that might cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. This device is intended only for OEM integrators under the following conditions: 1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and 2) The transmitter module may not be co-located with any other transmitter or antenna.
OEM integrators instruction 1. This module is restricted to installation in products for use only in mobile and fixed applications. 2. This module can only be used with a host antenna circuit trace layout design in strict compliance with the OEM instructions provided in this manual 3. The antenna circuit and layout must follow “WLL6540(RoHS) OEM board design guide” to design their own antenna circuit. Canada. Industry Canada (IC) This device complies with Industry Canada’s licence-exempt RSSs.
End Product Labeling This transmitter module is authorized only for use in device where the antenna may be installed such that 20 cm may be maintained between the antenna and users. The final end product must be labeled in a visible area with the following: “Contains transmitter module IC: 1353A-WLL6540”. Contient le module d'émission IC: 1353A-WLL6540 This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter.
