User Manual

Chapter 7 Troubleshooting
33
6. When confirm message appears, click OK.
7. Click Finish.
Chapter 7 Troubleshooting
My station cannot associate in Ad Hoc mode.
Make sure all the stations in the Ad Hoc network are set with the same SSID. You can set up one station to start the Ad Hoc network and wait briefly
before setting other stations. This prevents several stations from trying to establish a network at the same time, which can result in multiple singular
networks being established, rather than a single network with multiple stations associated to it.
If you are in the Europe using ETSI regulatory domain, Ad Hoc mode is not supported.
My station cannot access network resources in Infrastructure mode.
Even your link status indicates a successful connection with the Access Point, this connection applies to the “physical” network layer only. It is just like
pulling a cable between two wired computers. To access the network resource, you will need a login name and login password as implemented by most
of network operating systems. You should consult with your network administrator for required settings.