User's Manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Installing the Driver and Utility Software
- Chapter 3 Station Configuration
- Accessing the Atheros Configuration Utility
- Basic Configuration for Ad Hoc Network
- Basic Configuration for Infrastructure Network
- Edit the Security Tab
- Edit the Advanced Tab
- To Connect to an Existing Network
- To Modify a Configuration Profile
- To Remove a Configuration Profile
- To Switch to a Different Profile
- Chapter 4 Checking Status or Statistics
- Chapter 5 Tools
- Chapter 4 Uninstalling the Wireless LAN Card
6
Chapter 2 Installing the Driver and Utility Software
This chapter describes the first-time installation for the driver and software for the Wireless
LAN Card. Proper driver installation is to allow the device to operate on your host computer
while the utility software, a Windows program, is to help you configure and monitor your
Wireless LAN Card.
Note: As this Wireless LAN Card is an embedded solution, your computer is probably shipped
with its driver and software properly installed. If this is the case, ignore this chapter and
proceed with configuration steps in next chapter.
In case you need to re-install the driver and software for any reason, we recommend that you
remove any previously installed driver and software from your system first. Refer to the
section “Chapter 4 Uninstalling the Wireless LAN Card” for the instruction on how to
remove previous driver releases.