User's Manual

4.
Close the display panel and turn the computer upside down.
5.
Remove the battery.
6.
Remove the screw securing the memory module cover, then remove the
the cover.
7.
Hold the memory module by its edges at 45 degrees, so that the
goldfinger connector bar fits into the rear slot, then push and press the
module gently into the socket.
8.
Position the memory module cover on the computer and secure it with
the screw.
9.
Turn your notebook right side up.
10.
Reconnect any cables you disconnected.
11.
Turn on your notebook and verify that it correctly recognizes the amount
amount of memory currently installed in the computer
Top
Removing a Memory Module
1.
If the computer is on, click
Start
.
2.
In the Shut Down Windows dialog box, select
Shut Down
->
OK
.
3.
Remove all cables connected to the computer.
4.
Close the display panel and turn the computer upside down.
5.
Remove the battery.
6.
Remove the screw securing the memory module cover, then remove the
the cover.
7.
Release the memory module by gently pushing the latches on both
sides of the memory socket outward. The module will then pop up.
第 2 頁，共 4 頁Expanding Memory
2003/6/10
file://C:\WINDOWS\TEMP\~hhC8CC.htm