User's Manual

Figure 3-6: The Exit Menu
Pressing the [Esc] key does not exit this menu. You must select one of the options
from this menu or a menu bar item to exit this menu.
Each of the options on this menu is described below.
Save Changes and Exit
Once you are finished making your selections, choose this option from the Exit Menu
Menu to ensure the values you selected are saved to Non-Volatile RAM. Changes
you made to the Setup program must be changed to Non-Volatile RAM in order to
make them operative. Non-Volatile RAM differs from standard RAM memory in that it
it is sustained by an on-board battery and stays on even when the Notebook is
turned off.
Once your selections have been saved, the Setup program displays the following
message:
Setup Confirmation
Save configuration changes and exit now?
[Yes] [No]
System will reboot if Yes is selected and will stay in Setup if No is selected.
The next time you bootup the Notebook, the BIOS will attempt to load the values you
you saved in Non-Volatile memory. If these values cause the system boot to fail,
reboot and press [F2] to enter the Setup program. Once in Setup, you can try to
change the values that caused the system boot to fail. If the problem persists, load
the default values (see
Get Default Values below).
If you attempt to exit the Setup program without saving your changes, the program
will prompt you with a message asking if you want to save your changes before
exiting.
第 14 頁，共 16 頁The BIOS Setup Program
2003/6/10
file://C:\WINDOWS\TEMP\~hh98BD.htm