User Manual

Chapter 6 Commands Reference
Ignore this chapter if your Mini PCI Card does not support modem functions.
This chapter provides the AT command set for the Soft Modem chip set. Some of the
commands described within may not apply to your soft modem, depending on the build
options included in a license. The default values stated are typical for a full-featured Soft
Modem and may be different in reduced configurations.
6.1 Basic AT Command
47
\N3 V.42, MNP, or buffered (default). LU97 attempts to connect in V.42 error control
mode. If this fails, it will attempt to connect in MNP mode. If this also fails, LU97
connects in buffer mode and continues operation.
\N4 V.42 or disconnect. The modem attempts to connect in V.42 error control mode. If
this fails, the modem disconnects.
\N5 V.42, MNP, or buffered (same as \N3).
\N7 V.42, MNP, or buffered (same as \N3).
\Qn—Local Flow Control Selection