User Manual

Chapter 6 Commands Reference
Ignore this chapter if your Mini PCI Card does not support modem functions.
This chapter provides the AT command set for the Soft Modem chip set. Some of the
commands described within may not apply to your soft modem, depending on the build
options included in a license. The default values stated are typical for a full-featured Soft
Modem and may be different in reduced configurations.
6.1 Basic AT Command
45
\Jn—Adjust Bits/s Rate Control
\J0 Buffer mode. Error control is set or disabled with the \Nn command (default).
\J1 Forces the maximum DCE rate to the DTE rate.
\Kn—Set Break Control
When Modem Is Operating in Data Transfer Mode
\K0, \K2, K4 Enter on-line command mode. No break is sent to the remote modem.
\K1 Clear data buffers and send a break to the remote modem.
\K3 Send a break to the remote modem immediately.