User Manual

Chapter 6 Commands Reference

Ignore this chapter if your Mini PCI Card does not support modem functions.

This chapter provides the AT command set for the Soft Modem chip set. Some of the

commands described within may not apply to your soft modem, depending on the build

options included in a license. The default values stated are typical for a full-featured Soft

Modem and may be different in reduced configurations.

6.1 Basic AT Command

Z2 Reset and restore stored profile.

&Bn—V.32 Auto Retrain

&B0 Disable V.32 auto retrain (not supported).

&B1 Enable V.32 auto retrain (default).

&Cn—Data Carrier Detect (DCD) Control

&C0 The state of the carrier from the remote modem is ignored. DCD remains on at all

times.