User's Manual
Table Of Contents
- Table of Contents
- Section 1
- Section 2
- Section 3
- Installation and Configuration Procedures Under Windows 98/Me/2000
- 3.1 What You Need to Know About Windows 98/Me/2000
- 3.2 What You Will Need
- 3.3 Installing the Application and Drivers Under Windows 98/Me/2000
- 1. Insert the Firmware and Software Tools CD into your CD-ROM drive and locate the executable fil...
- 2. Follow the installation instructions from the InstallShield Wizard by pressing the “Next” button.
- 3. During the setup process, the window of Figure 3-1 will appear prompting you to select the ada...
- Figure 3-1. Selection of adapter type
- Figure 3-2. Operating Mode Dialog
- Figure 3-3. ESSID and Channel Dialog
- Figure 3-4. Operating Mode Dialog
- Figure 3-5. ESSID Dialog
- 1. Insert the Firmware and Software Tools CD into your CD-ROM drive and locate the executable fil...
- 3.4 Uninstall Procedure Under Windows 98/Me
- 3.5 Uninstall Procedure Under Windows 2000
- Section 4
- Section 5
Introduction
1-2
–16-bit PCMCIA bus interface
–Glueless SRAM interface for all MAC operations, supporting up to 16 MB of external
memory
–Integrated 6Kx32 bit internal SRAM, used for fast program code execution and
temporary storage of data
–Glueless Flash memory interface, supporting up to 16 MB on non volatile memory
for permanent storage of program code
–Enciphering/deciphering of wireless data by the implementation of the WEP
algorithm
–Supports 11, 5.5, 2, and 1 Mbps rates
1.4 Firmware
Features
The IEEE 802.11b firmware implementation for the AT76C503A-EK supports:
–Distributed Coordination Function
CSMA/CA
Backoff Procedure
NAV Management
ACK Procedure
Retransmission of unacknowledged frames
–RTS/CTS Handshake
–Duplicate Detection and Recovery
–Beacon Generation (ad-hoc mode)
–Probe Response (ad-hoc mode)
–Fragmentation and Reassembly
–Wired Equivalent Privacy Algorithm (WEP-40 bits, 128 bits)
–Auto Rate Fallback
–TSF synchronization
–Short Preamble
1.5 Driver Features
The drivers for the AT76C502-EK support:
–Roaming
–Preferred AP
–Dynamic configuration
–Site Survey
–Preamble Type detection
–Firmware Upgrade
–Authentication Algorithm (Open System, Shared Key)