User's Manual
Table Of Contents
- Table of Contents
- Section 1
- Section 2
- Section 3
- Installation and Configuration Procedures Under Windows 98/Me/2000
- 3.1 What You Need to Know About Windows 98/Me/2000
- 3.2 What You Will Need
- 3.3 Installing the Application and Drivers Under Windows 98/Me/2000
- 1. Insert the Firmware and Software Tools CD into your CD-ROM drive and locate the executable fil...
- 2. Follow the installation instructions from the InstallShield Wizard by pressing the “Next” button.
- 3. During the setup process, the window of Figure 3-1 will appear prompting you to select the ada...
- Figure 3-1. Selection of adapter type
- Figure 3-2. Operating Mode Dialog
- Figure 3-3. ESSID and Channel Dialog
- Figure 3-4. Operating Mode Dialog
- Figure 3-5. ESSID Dialog
- 1. Insert the Firmware and Software Tools CD into your CD-ROM drive and locate the executable fil...
- 3.4 Uninstall Procedure Under Windows 98/Me
- 3.5 Uninstall Procedure Under Windows 2000
- Section 4
- Section 5
Configuration & Monitor Utility
4-6
Advanced
By Choosing the
Advanced
option in any of the two modes, you can change advanced
configuration settings, such as the Preamble Type, Fragmentation Threshold, and
RTS/CTS Threshold (Figure 4-6). Figure 4-5 shows the recommended configuration for
the advanced settings. Before selecting Short Preamble, make sure that the other sta-
tions and APs are also supporting this feature.
Note:
The USB (A) card has an auto-detection feature therefore it automaticatilly
selects the Preable Type depending on the Access Point Preamble type. In
order to enable the Fragmentation and the RTS/CTS Threshold parameters
move the slide bar with your mouse and then use the right and left arrow keys of
your keyboard in order to select an exact number.
Figure 4-6.
Advanced Settings