User's Manual
Table Of Contents
- Table of Contents
- Section 1
- Section 2
- Section 3
- Installation and Configuration Procedures Under Windows 98/Me/2000
- 3.1 What You Need to Know About Windows 98/Me/2000
- 3.2 What You Will Need
- 3.3 Installing the Application and Drivers Under Windows 98/Me/2000
- 1. Insert the Firmware and Software Tools CD into your CD-ROM drive and locate the executable fil...
- 2. Follow the installation instructions from the InstallShield Wizard by pressing the “Next” button.
- 3. During the setup process, the window of Figure 3-1 will appear prompting you to select the ada...
- Figure 3-1. Selection of adapter type
- Figure 3-2. Operating Mode Dialog
- Figure 3-3. ESSID and Channel Dialog
- Figure 3-4. Operating Mode Dialog
- Figure 3-5. ESSID Dialog
- 1. Insert the Firmware and Software Tools CD into your CD-ROM drive and locate the executable fil...
- 3.4 Uninstall Procedure Under Windows 98/Me
- 3.5 Uninstall Procedure Under Windows 2000
- Section 4
- Section 5
Configuration & Monitor Utility
4-2
•Advanced
•Version
Note:
Please Note that at the very top of the Monitor and Configuration Utility of
the application (Figure 4-2), you can either select PCMCIA FastV-
NET (3.3V) or USB (A) FastVNET card.
Monitor
A typical screen of the application in Infrastructure mode is shown in Figure 4-2. The
configuration parameters are shown at the top of the screen (Operation Mode, Channel,
SSID, TxRate, Power Management Mode and MAC Address of the USB card). In the
middle of the screen there is information about the status of the communication (the
BSSID of the Access Point to which the card is associated, Signal Strength, and Link
Quality). In order to change the configuration parameters press the “Change” button,
make your changes and then press “Submit” in order to save your changes.
Figure 4-2.
A typical screen of the Monitor Utility in Infrastructure mode.