User's Manual

Installation and Configuration Procedures Under Windows 98/Me/2000
3-6
Figure 3-5.
ESSID Dialog
A soon as you have set your selections, press the “Next” button and a window appears
with a review of your installation settings. Please make sure that these values are the
desired ones. In case you have made a mistake, you can always select the “Back” button
to make a correction. Press the “Next” button to continue with the installation, and finally
press the “Finish” button for the installation to be completed.
Notes:1.You can now safely plug your USB (A) card. The “Add New Hardware Wiz-
ard” automatically loads the Drivers for your USB (A) card. As soon as the
procedure has been completed.
2.In the Windows 2000 installation procedure an extra window appears
prompting you to select whether you would like to install the “Digital Signa-
ture Not Found” or not. You can safely select “YES”.
3.4 Uninstall
Procedure Under
Windows 98/Me
In order to uninstall the Configuration & Monitor Utility from Windows 98/Me, you must
select the “Unistall Configuration & Monitor Utility” option (Start -> Programs ->
802.11 Wireless LAN -> Unistall Configuration & Monitor Utility). It is recommended to
stop the USB (A) card and “Exit” the application prior to starting the unistallation proce-
dure. If during the unistall procedure you receive an error message, please insert the
CD which contains the setup program and try to uninstall the Utility again.
The above procedure uninstalls the Configuration & Monitor Utility, but not the card
itself. In order to uninstall the Fast-VNET card from Windows 98/Me, you must double
click on the “Network” option in the “Control Panel” (Start -> Settings -> Control Panel).
Select the "USB Wireless LAN Adapter” card from the list and press the “Remove” but-
ton. The system will prompt you to re-boot. Press "Yes" to re-boot.