User's Manual
Table Of Contents
- Table of Contents
- Section 1
- Section 2
- Section 3
- Installation and Configuration Procedures Under Windows 98/Me/2000
- 3.1 What You Need to Know About Windows 98/Me/2000
- 3.2 What You Will Need
- 3.3 Installing the Application and Drivers Under Windows 98/Me/2000
- 1. Insert the Firmware and Software Tools CD into your CD-ROM drive and locate the executable fil...
- 2. Follow the installation instructions from the InstallShield Wizard by pressing the “Next” button.
- 3. During the setup process, the window of Figure 3-1 will appear prompting you to select the ada...
- Figure 3-1. Selection of adapter type
- Figure 3-2. Operating Mode Dialog
- Figure 3-3. ESSID and Channel Dialog
- Figure 3-4. Operating Mode Dialog
- Figure 3-5. ESSID Dialog
- 1. Insert the Firmware and Software Tools CD into your CD-ROM drive and locate the executable fil...
- 3.4 Uninstall Procedure Under Windows 98/Me
- 3.5 Uninstall Procedure Under Windows 2000
- Section 4
- Section 5
Installation and Configuration Procedures Under Windows 98/Me/2000
3-4
Figure 3-3.
ESSID and Channel Dialog
As soon as you have set your selections, press the “Next” button and a window appears
with a review of your installation settings. Please make sure that these values are the
desired ones. In case you have made a mistake you can always select the “Back” button
to make a correction. Press the “Next” button to continue with the installation, and finally
select the “Finish” button for the installation to be completed.