User's Manual
Table Of Contents
- Table of Contents
- Section 1
- Section 2
- Section 3
- Installation and Configuration Procedures Under Windows 98/Me/2000
- 3.1 What You Need to Know About Windows 98/Me/2000
- 3.2 What You Will Need
- 3.3 Installing the Application and Drivers Under Windows 98/Me/2000
- 1. Insert the Firmware and Software Tools CD into your CD-ROM drive and locate the executable fil...
- 2. Follow the installation instructions from the InstallShield Wizard by pressing the “Next” button.
- 3. During the setup process, the window of Figure 3-1 will appear prompting you to select the ada...
- Figure 3-1. Selection of adapter type
- Figure 3-2. Operating Mode Dialog
- Figure 3-3. ESSID and Channel Dialog
- Figure 3-4. Operating Mode Dialog
- Figure 3-5. ESSID Dialog
- 1. Insert the Firmware and Software Tools CD into your CD-ROM drive and locate the executable fil...
- 3.4 Uninstall Procedure Under Windows 98/Me
- 3.5 Uninstall Procedure Under Windows 2000
- Section 4
- Section 5
Installation and Configuration Procedures Under Windows 98/Me/2000
3-2
3.During the setup process, the window of Figure 3-1 will appear prompting you to
select the adapter type you are going to install. If you plan to install an
USB (A) card only, then you must choose the “Application & USB Drivers” option.
However, if you plan to install an PCMCIA card in the futureI, select the
“Application, PCMCIA & USB Drivers” option.
Figure 3-1.
Selection of adapter type
Application & PCMCIA Drivers
:
•By selecting this installation option, you will install the Applications (Configuration &
Monitor Utility and Firmware Upagrade Utility) and the latest PCMCIA drivers. If the
PCMCIA drivers have been previously installed and they have not been uninstalled
prior to the new installation the new drivers will ovewrite the old ones without
prompting you.
Application & USB Drivers
:
•By selecting this installation option, you will install the Applications (Configuration &
Monitor Utility and Firmware Upagrade Utility) and the latest USB (A) drivers. If the
USB (A) drivers have been previously installed and they have not been uninstalled
prior to the new installation the new drivers will ovewrite the old ones without
prompting you.
Application, PCMCIA & USB Drivers
:
•By selecting this installation option, you will install the Applications (Configuration &
Monitor Utility and Firmware Upagrade Utility) and the latest PCMCIA & USB (A)
drivers. If the PCMCIA & USB (A) drivers have been previously installed and they
have not been uninstalled prior to the new installation the new drivers will ovewrite the
old ones without prompting you.
Application Only
:
•By selecting this installation option, you will only install the Applications (Configuration
& Monitor Utility and Firmware Upagrade Utility).