User Manual
Table Of Contents
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Installing the Wireless LAN Card
- Chapter 3 Using Wireless LAN Utility
- Chapter 5 Windows XP Wireless Zero Configuration Utility
- Chapter 6 Uninstalling the Wireless LAN Card
- Chapter 7 Troubleshooting
- Appendix A Limited Warranty
- Appendix B Setting Up TCP/IP
- Glossary
11Mbps Wireless LAN Card User's Manual
20
Available Profiles
This section allows you to add, edit and remove a profile.
To add a new profile, click Add and then set up these parameters:
Screen Item Description
SSID Specifies the name of the WLAN group you want to participate in.
For Ad Hoc mode: A network name is mandatory. The SSID for
all stations in a single Ad Hoc network must be same.
For Infrastructure mode: If using the special SSID “any”, your
Wireless LAN Card will connect to the first compatible and “open”
AP with the best signal strength within the connection range.
WEP Specifies whether to enable WEP settings. See next section for more
information.
802.1x Do not check the “Enable IEEE 802.1x authentication for this
network” option unless you are going to join a 802.1x-enabled
wireless network.