User Manual
Table Of Contents
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Installing the Wireless LAN Card
- Chapter 3 Wireless LAN Monitor Utility
- Chapter 4 Using Wireless Tray Icon Functions
- Chapter 5 Windows XP Wireless Zero Configuration Utility
- Chapter 6 Disabling / Uninstalling the Wireless LAN Card
- Chapter 7 Updating the Device Driver and Software
- Chapter 8 Troubleshooting
- Appendix A Limited Warranty
- Appendix B Regulatory Compliance
- Appendix C Setting Up TCP/IP
- Appendix D Specifications
- Glossary
802.11b/g Wireless LAN Card User's Manual
30
Configuration Tab
The Configuration tab allows you to configure the parameters for the current connection or
the new one that you wish to connect to.
Screen Item Description
Network Name Enter the name of the WLAN group you want to participate in.
For Ad Hoc mode: A network name is mandatory. The SSID for
all stations in a single Ad Hoc network must be same.
For Infrastructure mode: Enter the Network Name you wish to
join in. If this field is left blank or using the special SSID “any”,
your Wireless LAN Card will connect to the first compatible and
“open” AP with the best signal strength within the connection range.
It allows your Wireless LAN Card to wander across networks with
different SSID (Network Name).
Operating Mode Select your operation mode as Infrastructure or Ad-Hoc
(peer-to-peer).
Transmit Rate The default setting (AUTO) allows the wireless adapter to adjust its
data rate as the signal strength warrants.