User Manual
Table Of Contents
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Installing the Wireless LAN Card
- Chapter 3 Wireless LAN Monitor Utility
- Chapter 4 Using Wireless Tray Icon Functions
- Chapter 5 Windows XP Wireless Zero Configuration Utility
- Chapter 6 Disabling / Uninstalling the Wireless LAN Card
- Chapter 7 Updating the Device Driver and Software
- Chapter 8 Troubleshooting
- Appendix A Limited Warranty
- Appendix B Regulatory Compliance
- Appendix C Setting Up TCP/IP
- Appendix D Specifications
- Glossary
15
Chapter 2 Installing the Wireless LAN Card
This chapter describes the installation process for the driver and software for the Wireless
LAN Card. Proper driver installation is to allow the device to operate on your host computer
while the utility software, Wireless LAN Monitor Utility, is to help you configure and
monitor your Wireless LAN Card.
After completing the steps listed above, if you need to set up the TCP/IP protocol for the
Wireless LAN Card to communicate with your network, refer to “Appendix C Setting Up
TCP/IP” for details.
System Requirements
To use the Wireless LAN Card, your computer must meet the following minimum
requirements:
!
Pentium-class PC, 300MHz or better recommended
!
64 Mbytes recommended
!
Hard disk space at least 30 Mbytes
!
UL listed I.T.E. computers
!
CardBus slot (for 32-bit CardBus Adapter)