User's Manual

Wireless Broadband Router User Manual
8
12. Click Finish to complete the driver installation. See “Device
Configuration” for the device configuration information.
Driver Installation (Previous Driver Installed)
If the system already has a previous release of the NDIS installed,
Windows does not prompt for the device driver when the WLAN
Card is inserted.
Follow the step below to update the NDIS driver:
1. Start System Properties from Control Panel. Under Hardware
tab, click Device Manager.
2. Within Device Manager, right-click “Wireless Network Adapter”
under “Network adapters” device node, and click Properties.
3. Click Update Driver...from the Driver tab. Note the Driver
Version that you are updating from. You may need to verify
this field again after driver update completes to make sure the
driver has been updated correctly.
4. Click Next to continue.
5. Choose “Display a list of the known drivers for this device so
that is can choose a specific driver.”
6. Click Next to continue.
7. Insert the Release CD into your CD-ROM drive. Click Have
Disk...to continue.
8. Click Browse to specify the location where the NDIS driver is
located (assuming D is the CD-ROM drive),the default folder is
“D:\ndi \bin \production \ndis5”.
9. Click OK to continue.
10. Select “Wireless Network Adapter” from the list.
11. Click Next to continue.
12. Click Yes to continue when Windows displays the warning
message.
13. Click Next to proceed with the installation.
14. The NDIS evaluation driver currently does not have a digital
signature from Microsoft. Therefore, Windows 2000 show a
warning message. Click Yes to proceed with driver installation.