User's Manual

Chapter 2 - Installing the Wireless LAN Card

Installing the Device Driver

Windows will automatically start the device driver installation when the Wireless LAN Card

is installed or when Windows starts.

For Windows 98(SE)

1. When the wizard appears, click Next. Then select Search for the best driver… and

click Next.

2. Insert the Installation CD into your CD-ROM drive. Check Specify a location and click

Browse to specify the path to D:\Driver\Win9x where D is the drive letter and click

Next.

3. When the driver is found, click Next to continue.

NOTE: If prompted, insert your Windows 98(SE) installation CD and then click OK.

4. Click Finish to complete the driver installation.

5. When prompted to restart your computer, click No and continue to the next task.

For Windows Me

1. When the wizard appears, select Specify the location … and click Next.

2. Insert the Installation CD into your CD-ROM drive. Select the check boxes for both

Search for the best driver … and Specify a location. Click Browse to specify the path

to D:\Driver\WinME where D is the drive letter and click Next.

3. When the driver is found, click Next to continue.

4. Click Finish to complete the driver installation.

If you need to set up the TCP/IP

address or the Subnet Mask,

refer to “Appendix C - Setting

Up TCP/IP” on page 35.

Have your Windows 98(SE)

/Me installation CD-ROM or

disks available; Windows may

prompt you for them.