User's Manual

1. Special requirements for remote control
1) When connected to Bluetooth, the remote control sends the Bluetooth key value;
2) Indicator light: red, each time the button is pressed, the indicator light flashes
Low voltage reminder: When the battery is low, the indicator light flashes quickly. As long as it is still in
operation, it will remain in the flashing state. When it is no longer operated by the remote controller, it will flash
5 times or flash 3 seconds, then stop and go out.
3) Support Bluetooth remote control online upgrade, and can trigger upgrade through HOST, the upgrade time
is less than 30s
4) Pairing method:
a) Press and hold the “HOME”+“BACK” button for 3 seconds at the same time, the indicator light will flash, and
the pairing success indicator will be on for 3 seconds and then off.
b) If the pairing is not successful, if you still press the “HOME”+“BACK” button, the pairing broadcast will be
sent all the time so that the user can pair.
c) Press the “HOME” + “BACK” button once to match successfully. Do not clear the pairing and then pair again.
After a key pairing is successful, the pairing broadcast can no longer be sent until the next time the button is
pressed.
Connection interval<12ms
5) Remote control distance: ≥10m
6) Bluetooth device name: RemoteBO6
7) The remote control's power-on lamp is on for 1 second.
8) The Bluetooth discovery mode has a duration of 2 minutes and the LED flashes at a flashing frequency of 2
Hz (500 ms period)
9) When the voice search is ready, the LED lights up after the ACK is sent from the host. The LED goes out
after the host detects the end of the voice, or the LED goes out after the 15 second timeout.
10) GATT battery service
Battery notifications are sent in % (%)): 2.2V: 0% 3.2V: 100%
The battery notification is sent only when the battery voltage changes or POR.