User's Manual

Femtocell Multi-band SOHO
Quick Start Guide
transmitter and receiver. When it’s
turned on, it receives and transmits radio
frequency (RF) signals. The system
controls the transmitted power level
within a range up to 0.5 W, cumulated
over all transmitting bands.
When using the European standards
EN50383, EN50384 and EN50385 and
the international standard IEC62232, the
SS2GHI Femtocell Multi-band SOHO and
SS2GEI Femtocell Multi-band SOHO
comply with the radiofrequency exposure
limits set by the European
Recommendation 1999/519/EC of 12
July 1999 (general public) and the
European Directive 2013/35/EU of 26
June 2013 (workers) at zero distance.
When using FCC OET Bulletin 65 and its
supplements, the SS2FHI Femtocell
Multi-band SOHO complies with FCC 47
CFR 1.1307(b) for radiofrequency
radiation exposure in uncontrolled
(general public) environments. The
SS2FHI Femtocell Multi-band SOHO shall
be installed and operated with a minimum
distance of 20 cm between the radiator
and your body.
EMERGENCY : The Femtocell Multi-band
SOHO does not operate during instances
of power loss. To make emergency calls
under this condition, please use a mobile
or land line phone.
POWER SUPPLY : Ensure that the voltage
specified corresponds to the power
socket to which you connect it. In case of
power loss (and therefore loss of
service), all mobile calls, including
emergency calls, will be redirected
automatically to the default mobile
(carrier) network. If you have no mobile
network coverage and need to make an
emergency call, please use a land line. In
case of a thunderstorm, please
disconnect the device to avoid damage.
For safety reasons, only authorized
service technicians should open the
device.
The AC/DC adapter meets the following
specifications:
Input power: 100-240VAC, 50-60Hz,
1.0A
Output power: 12VDC, 2A
The product supports PoE+ capability and
is compliant with the IEEE802.3at
standard with an input power of 48VDC at
0.6A. Power-over-Ethernet (PoE)
functionality is via the RJ-45 WAN port.
When connected to PoE networks, the
cabling must not route outside the
building.
INTERFACES:
All outputs ports are considered as
limited power sources (LPS).
DISPOSAL & RECYCLING : To facilitate
disposal and/or recycling, please respect
the sorting rules of your country or
region for this kind of device. European
regulations require the disposal of this
device at sales points or at designated
collection points such as drop-off
centers, etc.