User's Manual

38
whenever it connects to the remote server or ISP. If your Broadband Home Router’s WAN
port is connecting to a cable modem and the modem gets a dynamic IP from the ISP, you will
need to use this connection method.
Specify an IP address:
If your ISP provides you with a fixed IP for the WAN port, enter the IP address in this field.
PPPoE:
PPP over Ethernet is a protocol for connecting remote hosts to the Internet over an always-on
connection by simulating a dial-up connection.
User Name/Password: The user name and password to access the remote server or ISP.
MAX Idle Time: This value specifies the idle minutes that elapse before the LAN Home
Route automatically disconnects the PPP session. If no traffic is passing through during the
span of time your specified, the PPP session is terminated.
Dial On Demand: If checked, under disconnected status, if any client PC sends out request
for connection, the Broadband Home Router will dial the ISP automatically. In this case, if
the system administrator wants to disconnect the PPP session, just click the Disconnect
button.
Keep Alive: When enabled, a PPP session will still keep on line even when the idle time is
passed.
Connect: This button allows you to connect instantly without having to restart the device. To
make the connection, you may just click the Connect button without having to click Apply
button.
Service Name: Enter the name of your PPPoE service here.
Access Concentrator: Enter the access concentrator of your PPPoE service here as required
by your ISP.