User's Manual

Chapt er 1: Overview
1
C
C
h
h
a
a
p
p
t
t
e
e
r
r
1
1
:
:
O
O
v
v
e
e
r
r
v
v
i
i
e
e
w
w
Before installing the Router, please take a look at the front panel and rear panel of the router. Getting acquainted with
both panels will be helpful for installation later.
Physical Out look
F
F
r
r
o
o
n
n
t
t
P
P
a
a
n
n
e
e
l
l
The figure below illustrates the front panel of the Broadband Cable/DSL Wireless Router. It indicates the status of
the router in.
After powering on the router, the PWR LED will be on till powering off. These LEDs will not be on simultaneously.
When this device is transferring data, the LED will be blinking to indicate that which port that you are using.
LED Indicators
The ADSL Router is equipped with eight LEDs on the front panel as described in the table below (from left to right):
LED Color Status Description
Unlit Power off.PWR Green
Solid Power on.
Unlit Power off or initial self-test of the unit is OK.
Blinking
When software downloading or updating operation parameters located
in FLASH memory is in progress.
DIAG Green
Solid Initial self-test failure or programming FLASH memory failure.
Unlit Power off or no Ethernet carrier is present.
Blinking Ethernet carrier is present and user data is going through Ethernet port.
LAN Green
Solid Ethernet carrier is present.
Unlit
Power off or no radio signal (WLAN card is not present or fails to
function).
Blinking Traffic is going through Wireless LAN interface.
WLAN Green
Solid Wireless LAN interface ready to work.
Unlit Power off or line connection is handshaking or training is in progress.
Blinking User data is going through WAN port.
WAN Green
Solid Line connection is OK.