User's Manual

Wireless Broadband Rout er User’s Manual

On W ireless Clie nt

1. Install the wireless card driver and verify the wireless setting is as below:

The default SSID: IEEE 802.11 LAN

WEP encryption is disabled. Authentication Type is Open Key (or Open System according to your Wireless

LAN Card).

Use Infrastructure connection mode.

2. Check that the TCP/IP protocol is installed on your wireless client PC. Configure it to get a dynamic IP from the

Broadband Wireless Router.

3. Enter the default password - admin.

4. Go to Setup Wizard to finish basic configuration. Select your WAN connection type. Available options include:

Cable Modem

,Fixed-IP xDSL, Dial-Up xDSL(PPPoE). Follow the onscreen instructions to finish the basic

setting procedure. Finally, click Finish to exit basic setting web page.

N ot e: You should cont act your I SP for t he correct connection type and it s corresponding

configurat ion inform at ion.

5. When the connection is established, the client PCs can access the Internet or remote network through the

Broadband Wireless Router.

For the wireless-interfaced station, you need to set its SSID to the Broadband Wireless Router (AP)’s default SSID

value and disable the WEP encryption.

xDSL /ATU-R

Internet

Remote client

Network 1Network 2