User's Manual
Table Of Contents
- Table of Contents
- Section 1
- Section 2
- Section 3
- Section 4
- Access Point Configuration
- 4.1 Using the Ethernet Port
- 4.1.1 How to Install the SNMP Manager
- 4.1.2 Using the SNMP Manager
- Figure 4-1. Connecting to the ATMEL-AP using the SNMP Manager
- Figure 4-2. Agent found
- Figure 4-3. Agent not found
- Figure 4-4. ATMEL SNMP Bridge menu and submenus
- Figure 4-5. Bridge IP Configuration window
- Figure 4-6. Bridge Operational Mode window
- Figure 4-7. ATMEL SNMP Wireless LAN menu and submenus
- Figure 4-8. Wireless Physical Parameters window
- Figure 4-9. Wireless Privacy Options window
- Figure 4-10. Wireless Operational Settings window
- 4.1.3 How to Uninstall the SNMP Manager
- 4.2 Using the USB Port
- Section 5
2-1
Section 2
The AP Development Board
Figure 2-1 shows the Access Point development board. The basic fea-
tures of this board are outlined below:
•Interfaces directly to 10/100 IEEE 802.3 Ethernet networks.
•Supports IEEE 802.11b (High data rate) WLAN functions.
•Firmware is stored in a flash memory and can be upgraded remotely.
•Single 5V 1Amp universal power supply.
•Configurable through Ethernet and USB ports.
•Power and wireless activity LED indicators.
The MACless Radio card required is shown in Figure 2-2.
Figure 2-1.
AP development board