User's Manual
Table Of Contents
- Table of Contents
- Section 1
- Section 2
- Section 3
- Section 4
- Access Point Configuration
- 4.1 Using the Ethernet Port
- 4.1.1 How to Install the SNMP Manager
- 4.1.2 Using the SNMP Manager
- Figure 4-1. Connecting to the ATMEL-AP using the SNMP Manager
- Figure 4-2. Agent found
- Figure 4-3. Agent not found
- Figure 4-4. ATMEL SNMP Bridge menu and submenus
- Figure 4-5. Bridge IP Configuration window
- Figure 4-6. Bridge Operational Mode window
- Figure 4-7. ATMEL SNMP Wireless LAN menu and submenus
- Figure 4-8. Wireless Physical Parameters window
- Figure 4-9. Wireless Privacy Options window
- Figure 4-10. Wireless Operational Settings window
- 4.1.3 How to Uninstall the SNMP Manager
- 4.2 Using the USB Port
- Section 5
RTW020 AP H/W Specifications
Hardware
Model Type
11Mbps Wireless LAN Access Point
Frequency Band 2400 – 2483.5 MHz
Number of Allowed
Channels
11Ch ( for FCC)
13Ch (for ETSI)
14Ch ( for TELEC)
Ethernet interface
Support Both Ethernet and 802.3(Max. Bit rate 10Mbps)with
RJ-45 10BaseT connector
Serial interface
USB (console port for configuration)
DC Power Adapter DC Power Adapter
AC Input:100V~240V(50~60HZ)
DC Output:5V / 2.0A
Modulation Technique
Direct Sequence Spread Spectrum (CCK, DQPSK, DBPSK)
LED Indicator
Active(Green), Line Link(Green)
Power(Red)
Operational Conditions
Temperature 0-55
o
C
95%max. Humidity (no condensation allowed)
PCB Dimensions
116.77mm(L)*75.47mm(w)
Antenna type
2 External Antenna
Average Output Power 20 dBm
Power Consumption Rx :780mA Tx:1.2A
Standards IEEE 802.11b, Wi-Fi –Certified