User's Manual
Table Of Contents
- Table of Contents
- Section 1
- Section 2
- Section 3
- Section 4
- Access Point Configuration
- 4.1 Using the Ethernet Port
- 4.1.1 How to Install the SNMP Manager
- 4.1.2 Using the SNMP Manager
- Figure 4-1. Connecting to the ATMEL-AP using the SNMP Manager
- Figure 4-2. Agent found
- Figure 4-3. Agent not found
- Figure 4-4. ATMEL SNMP Bridge menu and submenus
- Figure 4-5. Bridge IP Configuration window
- Figure 4-6. Bridge Operational Mode window
- Figure 4-7. ATMEL SNMP Wireless LAN menu and submenus
- Figure 4-8. Wireless Physical Parameters window
- Figure 4-9. Wireless Privacy Options window
- Figure 4-10. Wireless Operational Settings window
- 4.1.3 How to Uninstall the SNMP Manager
- 4.2 Using the USB Port
- Section 5
Access Point Configuration
4-12
•Preamble Type: Select Short or Long Preamble Type.
•Authentication Type: Select Open System or Shared Key Authentication Type.
WEP Keys:
•WEP Key #1-#4: Set the value of the WEP key. WEP keys must be in HEX and in two
bytes per character format e.g. if you want the WEP Key #1 to be 12345, then you
must set it as 0102030405.
•Default Key: Select which of the four WEP Keys is going to be used. By selecting 0,
no WEP encryption will be used.