User's Manual
Table Of Contents
- Table of Contents
- Section 1
- Section 2
- Section 3
- Section 4
- Access Point Configuration
- 4.1 Using the Ethernet Port
- 4.1.1 How to Install the SNMP Manager
- 4.1.2 Using the SNMP Manager
- Figure 4-1. Connecting to the ATMEL-AP using the SNMP Manager
- Figure 4-2. Agent found
- Figure 4-3. Agent not found
- Figure 4-4. ATMEL SNMP Bridge menu and submenus
- Figure 4-5. Bridge IP Configuration window
- Figure 4-6. Bridge Operational Mode window
- Figure 4-7. ATMEL SNMP Wireless LAN menu and submenus
- Figure 4-8. Wireless Physical Parameters window
- Figure 4-9. Wireless Privacy Options window
- Figure 4-10. Wireless Operational Settings window
- 4.1.3 How to Uninstall the SNMP Manager
- 4.2 Using the USB Port
- Section 5
Access Point Configuration
4-3
When the connection has successfully been established, you get a message in the right
bottom corner indicating “All values retrieved”. If the message “Not all values retrieved”
appears, you need to repeat the above procedure (Figure 4-1).
As soon as the connection has been established, you are now able to start viewing or
setting the Access Point parameters. Under the “Setup” menu, there are three options
available (Figure 4-4):
•Bridge
•Wireless LAN
•Enable SNMP Traps
Figure 4-4.
SNMP Bridge menu and submenus
Under the “Bridge” option, there are two submenus: “IP Configuration” and “Operational
Mode”. The “Ethernet Address”, “IP Configuration” and “IP Mask” can either be viewed
or changed through the “IP Configuration” (Figure 4-5). If changes are made, you need
to “Download Changes” under the “File” menu in order to save them.