User's Manual
Table Of Contents
- Table of Contents
- Section 1
- Section 2
- Section 3
- Section 4
- Access Point Configuration
- 4.1 Using the Ethernet Port
- 4.1.1 How to Install the SNMP Manager
- 4.1.2 Using the SNMP Manager
- Figure 4-1. Connecting to the ATMEL-AP using the SNMP Manager
- Figure 4-2. Agent found
- Figure 4-3. Agent not found
- Figure 4-4. ATMEL SNMP Bridge menu and submenus
- Figure 4-5. Bridge IP Configuration window
- Figure 4-6. Bridge Operational Mode window
- Figure 4-7. ATMEL SNMP Wireless LAN menu and submenus
- Figure 4-8. Wireless Physical Parameters window
- Figure 4-9. Wireless Privacy Options window
- Figure 4-10. Wireless Operational Settings window
- 4.1.3 How to Uninstall the SNMP Manager
- 4.2 Using the USB Port
- Section 5
Access Point Configuration
4-2
Figure 4-1.
Connecting to the AP using the SNMP Manager
In case of a successful connection to the Access Point, the following window appears
(Figure 4-2). Press “OK”.
Figure 4-2.
Agent found
In case of an unsuccessful connection you receive the following message (Figure 4-3):
Figure 4-3.
Agent not found
If the above error message appears, you need to check if the AP has the desired IP
Address and is connected to the network. In order to check the validity of the IP Address
you need to ping the AP.