User's Manual
Table Of Contents
- Table of Contents
- Section 1
- Section 2
- Section 3
- Section 4
- Access Point Configuration
- 4.1 Using the Ethernet Port
- 4.1.1 How to Install the SNMP Manager
- 4.1.2 Using the SNMP Manager
- Figure 4-1. Connecting to the ATMEL-AP using the SNMP Manager
- Figure 4-2. Agent found
- Figure 4-3. Agent not found
- Figure 4-4. ATMEL SNMP Bridge menu and submenus
- Figure 4-5. Bridge IP Configuration window
- Figure 4-6. Bridge Operational Mode window
- Figure 4-7. ATMEL SNMP Wireless LAN menu and submenus
- Figure 4-8. Wireless Physical Parameters window
- Figure 4-9. Wireless Privacy Options window
- Figure 4-10. Wireless Operational Settings window
- 4.1.3 How to Uninstall the SNMP Manager
- 4.2 Using the USB Port
- Section 5
4-1
Section 4
Access Point Configuration
The AP configuration can be done either through the Ethernet port by using the
SNMP Manager application, or the USB port by using the DFU Utility.
4.1 Using the
Ethernet Port
In order to configure the AP through the Ethernet port, you must first install the
SNMP Manager application, which is a powerful and reliable tool used for the remote
configuration of the Access Point through the Ethernet port
.
4.1.1 How to Install the
SNMP Manager
In order to install the SNMP Manager you need to extract the “SNMPManager.zip” file,
which you will find into the “Utilities” folder of your CD, in a temporary file and then run
the program “setup.exe”. Follow the instructions of the set-up program and select the
directory where the application will be installed. Finally, a window will appear indicating
the completion of the installation.
4.1.2 Using the SNMP
Manager
Note:
Before using the SNMP Manager for configuring the AP, verify that the
Access Point IP address has been set-up following the procedure described in
the section “Setting the IP Address of the Access Point”.
On the Start Menu, select SNMP Manager. When the application opens, select
“Connect AP-Bridge” option which is under the “File” menu. Try to connect to the Access
Point, by typing its IP address in the panel which appears and at the Community field,
type "public" and then press OK (Figure 4-1).